The Challenges to Swim Spa Covers

Swim Spas represent unique obstacles when it comes to covering them.
We can all concur that the swim spa needs to be covered when not in use for all the same factors a hot tub needs a cover. The difficulty is that because of the length of the swim spa and the height of the sides, getting rid of and changing the cover can be a lot more difficult.
Getting a brand-new swim spa is an interesting event in life. You’re eagerly anticipating the exercise you’ll obtain from using it. Maybe you’re a little relieved to have actually finally made a selection from the different models you looked at. At any rate, you probably weren’t thinking much about the cover you would use.
Normally, the cover that gets home with your brand-new purchase will be a four section rigid foam filled cover that will split in the center and go off both ends.
No big deal.
Till it starts to get heavy.
Which it constantly does.
Every rigid foam filled Swim Spa Cover ever made winds up the same way and it is not the fault of the user. It’s a design flaw. Integrated in obsolescence due to the fact that as quickly as it is put in use over the warm water in your swim spa it is inescapable.
It’s not from rain, so having a taper won’t make any difference. In fact you might have it under a roof and the cover will still get heavy.
The reason is the steam from the water. The particles of steam are extremely small as they rise from the water surface. They make their way into the little cracks and crevices in the foam. Then as the steam cools it forms back into a liquid and becomes trapped in the cover.
It happens slowly and on a Swim Spa Cover which is made from private areas, at varying speeds. So ultimately you’ll see a couple of of the areas are truly getting heavy. The bar lifters on completions of the swim spa aren’t much assistance since you still need to lift that heavy cover back up onto the spa which is a lot higher than a regular spa.
This is why SpaCap.com created a different style for their Swim Spa Covers
Instead of using several foam panels to develop Swim Spa Covers that will eventually end up in some landfill, they created one that utilizes air chambers that do not suck up moisture.
In fact SpaCap.com Swim Spa Covers are lightweight, insulate much better, won’t blow away in a wind storm or be damaged by snow or hail.
Covered with Sunbrella Marine material, these covers will not fade, or fall apart at the joints either. So if you own a swim spa, and you intend to keep using it daily, SpaCap.com has the cover for it.
If you’re not prepared to purchase today, bookmark this site so you can discover it once again when you’re all set!

Leave a Reply

Your email address will not be published. Required fields are marked *